Toyota Pallet Truck Service Manual Safety Jacking Safety Jacking Safety You may need to jack the truck off the floor to perform maintenance procedures. When doing so, observe the correct safety precautions: Use extreme care whenever the truck is jacked up. Keep hands and feet clear from vehicle while jacking the truck. After the truck is jacked, put solid blocks beneath it to hold it. Do not rely on the jack alone to hold the truck. Tractor Section 1. Lower the forks completely. Remove any load. 2. Put all controls in neutral position. 3. Block the wheels to prevent movement of the vehicle. 4. Disconnect the battery connector. 5. Put the jack in the designated jacking points. 6.
Jack one side of the truck so that the drive tire is no more than 1 in. (25.4 mm) off the floor. 7. Block that side of the truck in position. 8. Jack the other side of the truck level with the first side. 9. Block that side of the truck in position. N OTE : After working on a vehicle, test all controls and functions to make sure operation is correct. Fork Section 1. Using the lift button, lift the forks to maximum height. 2. Block each fork by placing a block behind the load wheels. The tractor section will remain on the floor. 3. Lower the forks on the blocks. 4. Turn the truck OFF and disconnect the battery connector. 00700-CL398-07, Issued: 9 August 2007 2-9