Operation Section Product Lifting 20 SEBU9064 Operation Section Lifting eyes are designed and installed for specific engine arrangements. Alterations to the lifting eyes and/or the engine make the lifting eyes and the lifting fixtures obsolete. If alterations are made, ensure that correct lifting devices are provided. Consult your Perkins dealer or your Perkins distributor for information regarding fixtures for correct engine lifting. Lifting and Storage i05335230 Product Lifting i05335259 Product Storage Perkins are not responsible for damage which may occur when an engine is in storage after a period in service.
Your Perkins dealer or your Perkins distributor can assist in preparing the engine for extended storage periods. Condition for Storage The engine must be stored in a water proof building. The building must be kept at a constant temperature. Engines that are filled with Perkins ELC will have coolant protection to an ambient temperature of (−32.8° F). The engine must not be subjected to extreme variations in temperature and humidity. Storage Period An engine can be stored for up to 6 months provided all the recommendation are adhered to.
Illustration 18 g03380038 Typical example (1) Rear lifting eye (2) Front lifting eye Storage Procedure Keep a record of the procedure that has been completed on the engine. NOTICE Never bend the eyebolts and the brackets. Only load the eyebolts and the brackets under tension. Remem- ber that the capacity of an eyebolt is less as the angle between the supporting members and the object be- comes less than 90 degrees. Note: Do not store an engine that has biodiesel in the fuel system. 1. Ensure that the engine is clean and dry. a. If the engine has been operated using biodiesel, the system must be drained and new filters installed. The fuel tank will require flushing.
When it is necessary to remove a component at an angle, only use a link bracket that is properly rated for the weight. Use a hoist to remove heavy components. Use an adjustable lifting beam to lift the engine. All supporting members (chains and cables) should be parallel to each other. The chains and cables should be perpendicular to the top of the object that is being lifted. b. Fill the fuel system with an ultra low sulfur fuel. For more information on acceptable fuels refer to this Operation and Maintenance Manual, “Fluid recommendations”. Operate the engine for 15 minutes in order to remove all biodiesel from the system.
Some removals require lifting the fixtures in order to obtain correct balance and safety. 2. Drain any water from the primary filter water separator. Ensure that the fuel tank is full. To remove the engine ONLY, use the lifting eyes that are on the engine.