Features and Controls Gauges and Indicators 22 SEBU9064 Features and Controls 2. Inspect the cooling system for leaks. i05336041 Gauges and Indicators 3. Determine if the engine must be shut down immediately or if the engine can be cooled by reducing the load. Tachometer – This gauge indicates engine speed (rpm). When the throttle controller is moved to the full throttle position without load, the engine is running at high idle. The engine is running at the full load rpm when the throttle controller is at the full throttle position with maximum rated load. Your engine may not have the same gauges or all of the gauges that are described.
For more information about the gauge package, see the OEM information. Gauges provide indications of engine performance. Ensure that the gauges are in good working order. Determine the normal operating range by observing the gauges over a period of time. NOTICE To help prevent engine damage, never exceed the high idle rpm. Overspeeding can result in serious damage to the engine. The engine can be operated at high idle without damage, but should never be al- lowed to exceed high idle rpm. Noticeable changes in gauge readings indicate potential gauge or engine problems. Problems may also be indicated by gauge readings that change even if the readings are within specifications.
Determine and correct the cause of any significant change in the readings. Consult your Perkins dealer or your Perkins distributor for assistance. Ammeter – This gauge indicates the amount of charge or discharge in the battery charging circuit. Operation of the indicator should be to the right side of 0 (zero). NOTICE If no oil pressure is indicated, STOP the engine. If maximum coolant temperature is exceeded, STOP the engine. Engine damage can result. Fuel Level – This gauge indicates the fuel level in the fuel tank. The fuel level gauge operates when the START/ STOP switch is in the ON position. Engine Oil Pressure – The oil pressure should be greatest after a cold engine is started.
The typical engine oil pressure with SAE10W30 is 207 to 413 kPa (30 to 60 psi) at rated rpm. Service Hour Meter – The gauge indicates operating time of the engine. A lower oil pressure is normal at low idle. If the load is stable and the gauge reading changes, perform the following procedure: Indicators and Lamps The following indicator lamps can be installed, for more information refer to the Original Equipment Manufacturer (OEM) 1. Remove the load. 2. Reduce engine speed to low idle. Shutdown lamp 3. Check and maintain the oil level. Warning lamp Jacket Water Coolant Temperature – Typical temperature range is 71 to 96°C (160 to 205°F).
The maximum allowable temperature with the pressurized cooling system at 90 kPa (13 psi) is 125° C (257° F). Higher temperatures may occur under certain conditions. The water temperature reading may vary according to load. The reading should never exceed the boiling point for the pressurized system that is being used. Low-pressure oil lamp A multi function lamp is installed on the electric control module. i05336105 Monitoring System If the engine is operating above the normal range and steam becomes apparent, perform the following procedure: 1. Reduce the load and the engine rpm.