OPERATION 12.3.2 ADJUST SEAT BELT Always install a seat belt on machines equipped with ROPS. WARNING Before fitting the seat belt, check that there is no abnormality in the mounting bracket and mounting of the belt. If the belt is worn or damaged, replace it. Always fasten the seat belt before starting operations. Do not twist the left or right side of the seat belt when fastening it. Fastening and removing belt Fasten the belt so that it is tight without being too tight. 1. Sit on the seat, depress the brake pedal fully, and adjust the seat so that your back is pressed against the backrest. 2. After adjusting the seat position, adjust teaser belt (1).
Tense the teaser belt and install it when there is no one sitting in the seat. 3. Sit on the seat, take buckle (2) and tongue (3) in your left and right hands, insert tongue (3) into buckle (2), and pull the belt to check that it is securely locked. 4. When removing belt, raise the lever of buckle (2) to free the belt. Adjust the length of the buckle and tongue so that the belt follows your body without twisting, and adjust so that the buckle is in the middle at the front of your body. Adjust belt length To make belt shorter: Pull the free end of the belt at the buckle end or tongue end. To make belt longer:
Set the belt holding the buckle or tongue end at right angles to the buckle or tongue, and pull. 2-34