EXPLANATION OF COMPONENTS OPERATION ELECTRIC POWER TAKE-OUT ADAPTER NOTICE Do not use as a power supply for 12V equipment. This will cause failure of the equipment. When using as a power supply pickup, do not install equipment which exceeds 120W (24V x 5A). 1. Open battery cover (1) on the left side of the machine. 2. Pull out the electric power take-out connector for the cab. (A single-pole connector CN24 (2) for an optional device can be used.) Connector CN24 (2) is secured to the main harness with a band. When using CN24, remove it. After using it, secure it with the band again. Capacity of each connector:
480W (24V x 20A) Machine equipped with cab It is possible to remove the cigarette lighter and use the socket as a power supply. Capacity of cigarette lighter: 120W (24V x 5A) REMARK Ground the negative wire to the body work or ROPS. Do not ground it to the rubber mounted engine or valves.This will cause failures. If the wire is grounded to a point where there is still paint, the electricity will not flow smoothly, so remove the paint. 3-28