16. TROUBLESHOOTING 16.6.4 ELECTRONIC If an error code CONTROL appears on countermeasure table as shown SYSTEM the machine monitor display (normally displays TIME), follow the below in the self-diagnosis. Machine monitor trouble display Monitor display E02 Error mode Countermeasure PC-EPC valve system If the pump error operation can be carried out. However, immediately have the TVC valve system inspected by your Komatsu distributor. (x) E03 Swing error brake E05 Governor system system error override switch is set to the ON position, Turn the swing prolix switch ON to cancel the brake. When applying the swing brake, operate the swing lock switch manually.
Depending on the cause of the failure, it may be impossible to release the brake. In any case, have the system inspected immediately by your Komatsu distributor. (x) Governor will not execute the control function. Manually operate the governor-lever. To fix the governor lever at the full stroke position, use the retaining bolt holes on bracket. immediately have the governor your Komatsu distributor. CALL Error indicating that operation cannot be In this case, system inspected by Place the machine in a safe posture, then have it inspected immediately by your Komatsu distributor.
continued In the case where the monitor will not display error codes and work equipment operation and Have the machine inspected Komatsu distributor. immediately by your swing operation cannot be carried out. (x) For detail of operating 2-104 the pump override switch and the swing override switch, refer to “11.2 SWITCHES”.