23.
MAINTENANCE SCHEDULE CHART SERVICE EVERY Change oil in swing Check machinary oil level in damper ITEM 1000 HOURS PAGE SERVICE case case, add 3-63 oil 3-64 Check all tightening parts of turbocharger 3-64 Check play of turbocharger rotor 3-64 Check alternator belt tension and Replace corrosion replacce alternator belt 3-65 resistor cartridge 3-65 EVERY 2000 HOURS SERVICE Change oil in final drive case 3-66 Clean 3-67 hydraulic tank strainer Clean, check turbocharger Check alternator, Check engine starting 3-67 motor valve clearance, Check vibration 3-67 adjust 3-67 damper 3-68 EVERY 4000 HOURS Check water SERVICE pump 3-69 EVERY 5000 HOURS SERVICE Change oil in hydraulic tank USING 5000 Replacing hydraulic element On new machines, replace the element after the first 100 to 150 hours, then carry out further replacement of the element according to the table on the right.
Changing oil in hydraulic tank Change the oil according to the table on the right. Replacing additional filter element for breaker Use a guideline of 250 hours for use of the breaker (operating ratio for the breaker: 50 % or more), and replace the element according to the table on the right. 3-24 Replacement For machines equipped with a hydraulic breaker, the hydraulic oil deteriorates faster than for normal bucket digging operations, so set the maintenance intervals as follows.
interval (H) 23.2 MAINTENANCE INTERVAL WHEN HYDRAULIC BREAKER 3-70 4000 \ 3000 Replacement interval for hydraulic ofl J 2000 1000 S00} 0 (When not using breaker) F ~~ Additional filter element 40 Breaker ratio () Hydraulic filter element 60 80 1250 100 operating (When usine breaker only) AW354148