SAFETY PRECAUTIONS When replacing cutting edges and teeth, securely block the bucket for your protection. To install and remove bucket teeth, use a nonferrous hammer. It is hazardous to hammer on the teeth. Wear safety glasses with side shields or goggles to reduce chances of injury. BRAKES Block the tires to prevent machine movement before servicing the brakes. Test the parking brake periodically. If the parking brake does not hold the machine, correct the cause as soon as possible. Until the cause is corrected, park the machine on level ground and block the tires to prevent it from moving.
When testing the parking brake, be sure the area near the machine is clear of personnel and obstructions because the machine may move during the test. CAB/ROPS Do not attempt to repair a rollover protective structure (ROPS) after an accident. The ROPS is designed to bend during a rollover to protect the operator from sudden impact loads. Repaired structures do not provide the original strength and protection. O.S.H.A. regulations prohibit repair to damaged ROPS. Contact your Distributor for information on ROPS replacement. Do not operate the machine again until the ROPS has been replaced.
Do not cut, grind, weld or drill holes in the ROPS because this could weaken the structure or affect its energy absorption capability. Periodically inspect the ROPS for fatigue cracks. Cracks indicate a weakened structure which should be replaced for your protection. Do not use bleach, dye or solvents on the seat belt because this may weaken the webbing and result in personal injury. Clean the seat belt with warm water and a mild detergent. Replace belts with worn, frayed, torn, faded, stiff or rotted webbing. COOLING Hot, scalding coolant can spray out if the radiator cap is removed suddenly.
Relieve system pressure by slowly turning cap to the first notch or lifting the safety lever (if equipped). Remove the cap ONLY after the pressure is relieved. Use extreme caution when adding coolant to a hot radiator to avoid being burned. Wear gloves and goggles and keep face away from the filler neck. ELECTRICAL Batteries give off a highly flammable gas. DO NOT SMOKE or allow sparks or open flame near the batteries because a fire or explosion could result. BE SURE the electrical starting switch is off when connecting or disconnecting batteries to minimize the chance of sparks and explosion. I-II