OPERATION C. CAUTION MONITOR LAMP GROUP (Emergency stop items) If any abnormality occurs while the engine is running, the appropriate monitor lamp and warning lamp (E) will flash and the alarm buzzer will sound intermittently at the same time. * If any monitor lamp flashes, stop the engine and correct the problem immediately. * However, if the machine is equipped with operated, only the monitor lamp will flash. the ground driven steering feature and this steering system is being D.
METER AND PILOT LAMP GROUP This group consists of an air pressure gauge, engine coolant temperature gauge, torque converter oil temperature gauge, fuel level gauge, speedometer, service meter and pilot lamp display. E. WARNING LAMP The warning lamp will flash when there is an abnormality in any item of group (B). The warning lamp will flash and the alarm buzzer will sound when there is an abnormality in any item of group (C) or when the parking brake is applied, but the directional lever is not in neutral.
* However, if the machine is equipped with the ground driven steering feature and this steering system is being operated, the warning lamp will not light up and the alarm buzzer will not sound SYSTEM CHECK To check the monitor panel system, turn the starting switch to “ON” before starting the engine. Then all monitor lamps, gauges and the warning lamp light up for about 3 seconds and the alarm buzzer sounds for about 1 second. Three figures, “188”, are displayed on the speedometer while the monitor system is being checked. After that all lamps go off and the buzzer stops. If any monitor lamp does not light up, ask your distributor to inspect that monitor lamp.
Ll 1 AH023 NOTE:Monitor /amp (I) does not light up because if is not used on this machine. Monitor lamp (2) lights up only if the machine is equipped with the ground driven steering option. * When the starting switch is turned to ON, if the directional lever is not at neutral, the warning lamp will flash and the alarm buzzer will continue to sound. If this happens, return the lever to neutral. The lamp will go out and the buzzer will stop. * To check the monitor immediately when the engine is stopped, wait for at least 30 seconds after the engine is stopped. 2-4