Warnings And Cautions - Section 22 OM2200 Page 22-2 A warning instruction is applied below the parking brake and the rear wheel brake lock switches which are located to the right of the steering column on the instrument panel. Pushing the top of the rocker-style switch turns the function ON, pushing the bottom, turns it OFF. goggles, rubber gloves and rubber apron when handling and servicing batteries. Get proper medical help immediately, if required. This plate is placed on both battery boxes and near the battery disconnect switches to indicate that the battery system (24VDC) is a negative (-) ground system.
These decals are placed above the battery disconnect switches on the right side of the front bumper to indicate OFF and ON posi- tions of the switches. brake is spring applied and hydraulically released. It is designed to gine is shutdown and keyswitch is turned OFF. The truck must ing the parking brake, or damage may occur to parking brake.To a cker switch toward the ON symbol. To release the parking brake, The parking brake is spring when the engine is shutdo before applying the parking press the rocker switch tow toward the OFF symbol. W brake indicator light (A3, overhead pane NOTE: Do not use the parking brake a caused by loading or dumping could cau The wheel brake lock switc dumping.
It applies the rea this brake to stop the truck engine shut down, the hydr Attached to the exterior of both batter danger plate. This plate stresses the ne ing any sparks near the battery. Whe 24VDC power source is used for auxiliar must be OFF prior to making any con brake is spring gine is shutdo ing the parking cker switch tow necting auxiliary power cables, positiv polarity; connect the positive (+) post connect the negative (-) lead of the auxil good frame ground. Do not connect to of the truck battery or near the batte completes the circuit but minimizes da the batteries. Sulfuric acid is corrosive and toxic. Us