COLD WEATHER OPERATION 4. Put fuel cut-off switch (3) in ON position. (When releasing the switch, it will return to ON position.) 5. When preheater switch (4) is put * When the engine cooling water When the pre-heat monitor is still illuminated and the starting switch is put in START position, the glow plug will get wet, and there will be no ignition, so be temperature is over 13”C, if the preheat switch is returned to AUTO, the preheating monitor will go out and automatic pre- heating cannot be carried out. If normal starting is difficult, use the procedure given in “Starting in the ON position, the pre-heat monitor will light and automatic pre-heating will start.
If the pre-heating monitor lights, return the preheater switch to AUTO position. (When releasing the switch, it will return to AUTO position.) careful of starting problems. When starting, and the starting motor is rotating, the monitor will start to flash. If the flashing stops after the engine starts, there is nothing wrong. Do not continue cranking the engine for more than 20 seconds. * using manual preheating” to start the engine. Depress the accelerator pedal (5) about half way. Pre-heating finishes in about 80 seconds. The pre-heating monitor lamp will stop illuminating so turn starting switch key (2) to START position to start. 6. 7. W-02889 - 65 -