INSTRUMENTS AND CONTROLS Sr To check the monitor immediate- ly when the engine is stopped, wait for at least 30 seconds after the engine is stopped. @CAUTION MONITOR GROUP (Emergency stop items) If any abnormality occurs while the engine is running, the appropri- ate monitor lamp will flash and the alarm buzzer will sound intermittent- ly at the same time. @J METER GROUP This group consists of air pres- sure gauge, engine water tempera- ture gauge, torque converter oil tem- perature gauge, fuel gauge, speedometer, service meter and pilot display. @CHECK MONITOR GROUP (Check items before starting) If there is any abnormality, the appropriate monitor lamp will flash.
* When the engine is started, these monitor lamps will go off even if there are abnormalities. * However, when the emergency steering is being operated, only the monitor will flash. The alarm buzzer will not sound, and the central warning lamp will not light up. * If any monitor lamp flashes, stop the engine or run it at a low idling speed, and repair it immediately. @ WARNING LAMP The warning lamp will flash when there is an abnormality in any @ group item. The warning lamp will flash and the alarm buzzer will sound when there is an abnormality in any @ group item or when the parking brake is applied, but the directional lever is not at neutral.
@CAUTION MONITOR GROUP (Caution items) If any abnormality occurs while the engine is running, the appropri- ate monitor lamp will flash to indi- cate the abnormality. * Even if any monitor lamp flashes, the machine can operate, but it should be repaired as soon as possible. -6- w-02009