EVERY 1000 HOURS SERVICE e. ROPS CANOPY f. CORROSION RESISTOR l Turbocharger oil feed pipe (inlet line) Tightening torque: 2.8 - 3.5 kgm l Turbocharger oil feed pipe (out line) Tightening torque: 6.0 - 7.5 kgm 1. 2. Loosen bolt, then remove cover. Check that there is no looseness in mounting bolts (1) of the 1. Open the engine side over located at the right of the body and lock open lock. 2. Close valve (I 1. 3. Using the filter wrench provided, remove cartridges (2) (2 pieces) by turning it counterclockwise. 4. Fit a new cartridge after applying a dab of engine oil to the seal face. ROPS canopy. If any bolt is loose, tighten it. Tightening torque: 280 * 30 * 3. sr kgm Install cover.
The tightening torque is large, so a power wrench is needed when tightening. Please request your Komatsu distributor to carry out this work. - 94 - w-04305