g. After installing the gasket (157892-1500) on the nozzle, use the cap nut (157892-4000 : SW22mm) to fix the nozzle onto the nozzle holder. NOTE : While tightening the cap nut, keep checking to see if the lock pin comes all the way into the nozzle. NOTE : Tighten the retaining nut until it resists hand tightening, then further tighten it using a torque wrench. h. Be sure to follow the specified torque rating when tightening the adjusting retaining nut. 7 EQM4036I i. With the cap nut facing upward, install the nozzle holder on the plate. j. Assemble the push rod (2), primary spring (3), and adjusting screw (4) on the nozzle holder in the order described. (4) (3) k.
Install the gasket and cap nut onto the adjusting screw. (2) - 142 - MAINTENANCE OF MAJOR COMPONENTS Torque 6.0 ~ 8.0 kg.m