Run-out Support the camshaft on two V blocks and check for run-out using a dial indicator. Correct or replace the cam shaft if the amount of run-out is beyond the value indicating need for servicing. EA0M4066 3) Cam shaft end play Push the thrust plate toward the cam gear. With a feeler gauge, measure the and camshaft gear. If the end play is excessive, replace clearance between the thrust plate the thrust plate. 간극 게이지 Feeler gauge EA0M4067 3.2. 6. Cam shaft 1) Defect check Visually check the crankshaft journal and crank pins for scores or cracks. Using a magnetic particle test and color check, inspect the crankshaft for cracks, and replace the crankshaft which has cracks.
2) Wear With an outside micrometer measure the diameter of the crankshaft jour- nals and pins in the directions as shown, and compare the measured values to determine the amount of wear. EAMD057I - 68 - INSPECTION AND MEASUREMENT Standard Limit 0.05 mm 0.2 mm Standard Limit 0.13 ~ 0.27 mm 0.30 mm