Apply engine oil to the entire face of the tappets and slide them into the tappet holes on the cylinder block. Wet the cam bush inside diameter and camshaft with oil, and carefully camshaft. Check to see that the camshaft assemble them while turning the rotates smoothly. EDM2060I 3.3.5. Crankshaft Install the main bearing machined Oil port and passage Key groove with two holes in the cylinder block so that the key is aligned with the key groove, then apply oil to the bearing surface. EA0M4083 Heat the crankshaft gear for at least 10 minutes to 120˚C, then apply sealant (Loctite # 641) to the inside wall of the heated crankshaft gear evenly before inserting it to the end of crankshaft.
EA8M3014 - 77 - REASSEMBLY