3.3.8. Flywheel Install a guide bar into a bolt hole on the crank shaft, and lift the flywheel to align the dowel pin with the pin hole on the flywheel for temporary assem- bly operation. Install bolts in the remaining holes, take out the guide bar, then install a bolt in the hole where the guide bar had been inserted. Tighten the fixing bolts using a torque wrench in a diagonal sequence to specified torque. 3.3.9. Magnetic pick-up sensor Move the lock nut to hexagonal side of sensor completely. Rotate (Clcokwise) the pick-up sensor Rock nut Ring gear on flywheel housing, until the end of it reach on fly wheel ring gear.
Then rotate (Counter clockwise) the pick-up sensor for 270˚ (gap 1.0 mm) M16 x 1.5 and fix lock nut. Tolerance limit is 27˚ (gap L 0.1 mm) EPM2030I Flywheel Housing 27 Tolerance limit 27 270 EPM2031I - 80 - REASSEMBLY EAMD081I 4 8 6 1 2 5 7 3 EAMD097I Torque 18 kg.m