3.3.12. Fuel injection pump drive gear Mount gasket by aligning the bolt holes with the pin holes on the bear- ing housing. Tighten the fixing bolts in the direc- tion of fuel injection pump. EAMD027I 3.3.13. Timing gear case cover Install dowel pin on the timing gear case. Mount a gasket by aligning the fixing bolt holes with those on the gasket. Align the dowel pin with the cover pin hole, then install the cover with light tap. Tighten the fixing bolts beginning with the oil pan fitting face. 3.3.14.
Front oil seal Apply lubricating oil to the outside of the oil seal and timing gear case inside diameter and fit them over the crankshaft, then assemble the oil seal using an oil seal fitting jig. 오일시일 고정지그 Oil seal fitting jig EAMD086I 3.3.15. Cylinder liner Stand the cylinder block so that the flywheel faces downward. Thoroughly clean the liner flange fit- ting surface and bore inside with com- eign substances. After the cleaning operation, make the pressed air to prevent the entry of for- cylinder liner dried up and push it into the cylinder block by hand. Wet the liner inside diameter with EAMD087I engine oil. - 82 - REASSEMBLY