Appendix A i5601E Digital Display Setup The i5601E was set up at the factory with the keys assigned and locked as shown on page 4 of this manual. This mode is the default mode and allows start up and operation of the engine. It serves many applications quite well. The i5601E Digital Display unit has many additional features and capabilities. This section of the book shows the use of some of these features. Changing the basic set up is typically accomplished in one of two ways. 1. Go to the systems menu and alter basic selections 2. Enable the right arrow key (5) on the basic screens to allow changing of the data shown in the default displays.
To enter the Main Menu press and hold key 5 until the menu appears. To move around the menus use the softkeys at the bottom of the screen. The function of a particular softkey changes from screen to screen to whatever is most appropriate for the given screen. Keys 1 2 3 4 5 NOTE: Any changes to the setup menus may require reconfiguring the i5601E HOT KEY SETUP. Electronic Control System: Operation Manual for BY Series Engines with Unlimited Controls Page 18 © Yanmar 2008