OM2033 Safety - Section 20 General Safety Page 20-9 KEEP THE MACHINE CLEAN RADIATOR WATER LEVEL Spilled oil or grease, or scattered tools or broken pieces are dangerous because they may cause you to slip or trip. Always keep your machine clean and tidy. If it is necessary to add water to the radiator, stop the engine and allow the engine and radiator to cool down before adding the water. If water gets into the electrical system, there is danger that the machine may not move or may move unexpectedly.Do not use water or steam to clean the sensors, connectors, or the inside of the operator's compartment. Slowly loosen the cap to relieve pressure before removing the cap.
USE OF LIGHTING RULES TO FOLLOW WHEN ADDING FUEL OR OIL When check- ing fuel, oil, coolant, or battery elec- trolyte, always use lighting with anti- explosion specifications. If such lighting equipment is not used, there is danger or explosion. Spilled fuel and oil may cause a person to slip, always wipe it up imme- diately. Always tighten the cap of the fuel and oil fillers securely. Never use fuel for washing parts. PRECAUTIONS WITH BATTERY Always add fuel and oil in a well-ventilated place. When repairing the electrical system or when carrying out electrical welding, remove the negative (-) terminal of the battery to stop the flow of current.
HANDLING HIGH-PRESSURE HOSES Do not bend high-pressure hoses or hit them with hard objects. Do not use any bent or cracked piping, tubes or hoses. They may burst during use. Always repair any loose or broken fuel hoses or oil hoses. If fuel or oil leaks, it may cause a fire.