General Section Below are abbreviations that may appear on the Identification, Lift Capacity and Attachment Plate and their meanings. Mast Abbreviations STD - Standard Mast (single inner member, low free lift) Attachment Abbreviations (includes Special Forks) SC- Special Carriage-increased width, height or outreach SSS - Shaft-type Sideshift Carriage FF - Full Free Lift Mast (single inner member with high free lift duplex cylinder) HSS - Hook-type Sideshift Carriage (ITA) CW - Counterweight SF - Special Forks FFT - Triple Lift Mast (two inner members) with either low or full free lift characteristics.
SWS - Swing Shift, Sideshift RAM - Ram or Boom QUAD Quadruple (Quad) Mast(with three inner members) DBCBH - Double Cube Block Handler HFP - Hydraulic Fork Positioner CR - Crane Arm or Crane Boom NOTE: When only a mast-type is listed on the identification plate, a standard carriage and forks are used. TH - Tire Handler CTH - Container Handler LPP - Load Push-Pull Device CC - Carton Clamp RC - Roll Clamp LS - Load Stabilizer PWH - Pulp Wood Handler SS-ST - Sideshift-Side Tilt Carriage 46