Operation Section Instrument Panel 1. Engine Ignition Start Switch The key switch is a four position switch. Position (1) is ACCESSORY ON. Position (2) is OFF. Position (3) is ON or RUN and accessory ON. Position (4) is START, which engages the starter. After the key has been turned to the START position, the key must be returned to the OFF position before it can be turned to the START position again. 2. Engine Coolant Gauge Indicates coolant temperature. If the pointer moves beyond the green band while operating the lift truck, overheating is indicated. Park the lift truck and stop the engine. Check the cooling system for a malfunction.
The point will be at the end of the green band when the coolant temperature reaches approximately 103°C(217°F) on all engines. 3. Transmission Oil Temperature Gauge Indicates transmission oil temperature. If the pointer moves beyond the green band while operating the lift truck, excessive transmission oil temperature is indicated. Park the lift truck and stop the engine Check the system for a malfunction. The pointer will be at the end of the green band when the transmission oil temperature reaches approximately 120°C (248°F). 4. Fuel Level Gauge Indicates fuel level in the fuel tank. 5. Hour Counter Indicates the total number of hours the engine and the lift truck have operated.
The hour meter will operate when the ignition switch is in the ON position, whether the engine is running or not. The hour meter is used to determine lubrication and maintenance intervals. 6. Speed meter Indicates the truck travelling speed(km/h). 7. Turn Signal Lever This is the lever to indicate the turning direction of the lift truck. As this lever is maneuvered, the signal lamp blinks. 8. Horn Switch To give alarm to fellow worker(s) around and in the path of your truck, press the rubber at the center of the handwheel. Don’t run the truck while the alarm is sounding. It is dangerous to do so, since poor effect is expected. 48 R Turn to the right N Neutral L Turn to the left WARNING