Operation Section Starting the Engine Prestart Conditions NOTE: The engine will not start unless the transmission directional control lever is in the NEUTRAL position. Starting a Warm Diesel Engine 1. Turn the ignition key to the ON position and then to START position, without waiting for the preheat light to go OFF. At the same time fully depress the accelerator. 2. Release the ignition key when the engine starts and release the accelerator pedal to a low idle position. LP Engine LP fuel is flammable and can cause personal injury. Inspect LP fuel lines and fitting for leaks. Inspect tank for secure mounting. Typical Example 1. Engage the parking brake, if not already engaged. 2.
Place the transmission directional control lever in NEUTRAL position. Diesel Engine Starting a Cold Diesel Engine 1. Turn the ignition key to the ON position. The start preheat light will come ON. The preheat light will stay ON approximately seven seconds, depending on the ambient air temperature. 1. Open the tank fuel valve by slowly turning the valve counterclockwise. Observe the LP gauge (if equipped). 2. Turn the ignition switch to the START position. Release it when the engine starts. 3. If the engine does not start, Do not press on the accelerator pedal. Turn the starter switch to OFF position, the repeat step 2 and depress the accelerator pedal slightly during cranking. 4.
Allow the engine to warm up slowly. Do not engage the starter for more than 10 seconds. NOTICE 2. When the preheat light goes OFF, turn the ignition key to the START position, with the accelerator pedal fully depressed. 3. Release the ignition key when the engine starts and release the accelerator pedal to a low idle position. 4. If the engine stalls or does not start, turn the ignition key to the OFF position, then repeat steps 1 thru 3. 66 WARNING