. ATTACHMENTS, OPTIONS HANDLING JOYSTICK STEERING SYSTEM (G) Adjusting headrest angle Rotate the backrest to the front or rear and set to the desired angle. Amount of adjustment: 38 degrees (H) Adjusting headrest height Move the headrest up or down and set to the desired height. Amount of adjustment: 100 mm (3.9 in) 6 - 13 (D) Setting seat for weight Pull lever (3) up fully (pull it until a clic k can be felt). When the lever is released, the weight adjustme nt is carri ed out automatically. To ensure that the w eight adjustment is carried out correctly, the operato r should s it in the n ormal operating position when operating th e lever.
If the operator raises his body from the sea t or chan ges the a mount of weight applied to the seat during adjustment, the air in the suspension may be discharged. When operators change shifts, the n ew operator should pull lever (3) up fully (pull it until a click it is felt). Wh en the lever is released, the weight adjustm ent is carried out automatically. If lever (3) is pulled lightly, the weigh t adjustment starts, but always pull the lever up f ully (pull it un til a click is felt) before releasing it.
REMARK When making initial adjustment or when adjusting the weight settings when operators change shifts, set the operato damping force of the suspension damper"), then adjust it to match to the hard setting and the height seat goes down, set the damping the weight again. After completin damper to the desired strength. damper to the soft setting (for details, see "Adjusting hardnes s of suspension the operator's weight. If the damping force of t he suspension d amper is l eft set of the seat is adjusted, even if the height is raised , the seat may go down .
If the force of the suspension damper to the soft setting, lo wer the s eat, then adjust g adjustment of the weight and height, set the dampin g force of the suspension pension must be adjusted to match the operator's weight. Adjust the weight To protect the operator, the sus before starting operations. When adjusting, do not remove y our weight from the seat or change the load in any oth er way. If this is don e, the air may be released from the sus pension's seat. (E) Fore-and-aft adjustment of seat cushion Operate lever (4) up, set the seat cu shion to the desired position, then release th e lever. Fore-and-aft adjustment: 60 mm (2.
4 in) (F) Adjusting reclining angle ack cushion to the front or rear. Operate lever (5) up and move the b But your back firmly against the seat back when carrying out this adjustment. If yo u move your bac k away fro m the seat back, the seat back may sudde nly spring forward. grees is free) Amount of adjustment Forward tilt: 10 degrees (over 10 de Rear tilt: 36 degrees NOTICE If the seat back is reclined too far, the se at back may hit the rear glass, so use it in a position where it does not contact the glass. (J) Lumbar support Turn the knob (6) to the right or left t o give the suitable amount of lumbar support