Group 43 MID 130 Transmission Control Unit, Fault Codes Troubleshooting MID 130 Transmission Control Unit, Fault Codes The manufacturer diagnostic tool is the preferred tool for performing diagnostic work. Contact your local dealer for more information or visit “www.premiumtechtool.com”. The control modules on the information link communicate according to the SAE J1587 standard. The standard has been extended with Volvo’s own supplement (PPID, PSID). The fault codes set by the control modules contain information that is described by the following abbreviations. MID Message Identification Description: Identification of a control module. SID Subsystem Identification Description:
Identification of a component. PID Parameter Identification Description: Identification of a parameter (value). PSID Proprietary Subsystem Identification Description Volvo: Unique identification of a component. PPID Proprietary Parameter Identification Description Volvo: Unique identification of a parameter (value). FMI Failure Mode Identifier: Identification of fault types.
FMI Table 7 FMI Display Text SAE Text 0 Too high value Data valid, but above the normal work range 1 Too low value Data valid, but below the normal work range 2 Incorrect data Data erratic, Intermittent or incorrect 3 Electrical fault Voltage above normal or shorted high 4 Electrical fault Voltage below normal or shorted low 5 Electrical fault Current below normal or open circuit 6 Electrical fault Current above normal or grounded circuit 7 Mechanical fault Mechanical system not responding properly 8 Mechanical or electrical fault Abnormal frequency, pulse width or period 9 Communication fault Abnormal update rate 10 Mechanical or electrical fault Abnormal rate of change 11 Unknown fault Failure mode not identifiable 12 Component fault Bad intelligent device or component 13 Incorrect calibration Out of calibration 14 Unknown fault Special instructions 15 Unknown fault Reserved for future assignment by SAE Data Formal Subcommittee