. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 125 BEFORE STORAGE rage (more than one month), store as follows. d house the machine in a dry building. Never leave it outdoors. ed outdoors, select a flat area and cover the machine with a waterproof sheet. This prevents moisture from collecting. il before storage. f the hydraulic cylinder piston rod with grease. When keeping in long-term sto rage (more than one month), store as fo llows. Wash and clean all parts an d house the machine in a dry building. Never leave it outdoors.
If the machine must be stor ed outdoors, select a flat area and cover the m achine with a waterproof s Completely fill the fuel tank. This prevents moisture from collecting. Lubricate and change the o Coat the exposed portion o f the hydraulic cylinder piston rod with gr Disconnect the negative ter minals of the battery and cover it or remov e it fro m the m achin e and store it s eparately. Apply the parking brake. Set the tire inflation pressur e for each tire to within the range of the s pecifie d inflatio n pressur e for the t ype of tire. Push the retarder control le ver forward to the OFF position. the N position and turn the starting switch OFF.
Place the gear shift lever at the N position and turn the starting swit ch OF To prevent rust, fill with Kom atsu genuine supercoolant (AF-NAC) to give a density of at l east 30% for t he engine coolant. If it is necessary to perform the ru st-prevention operation while the machine is i ndoors , open th e door s and windows to improve ventilation and prevent gas poiso During the storage period, ope rate the machine once a month to preve nt loss of the oil film at t he lubrica ted parts.
At the same time, charge the Before operating the work equ ipment, wipe off all the grease from hydraulic p iston ro NOTICE If the machine has been stored w ithout carrying out the monthly rust-prevent ion operation, c onsult your Komatsu distributor before using it. When using the machine after long-term storage, do as follows before using Wipe off the grease from th Add oil and grease at all lub When the machine is stored for a long period, moisture in the air will m ix with the oil. Chec k the oil befor e and after starting the engine. If there is water in the oil, change all the oil. PRECAUTIONS BEFORE TRAVELING AFTER LONG-TERM STORAG 1. Check all the oil and wate 2.
When traveling after long-t or 1 km to run the machin erm storage, travel forward at a speed of 10 to 1 5 km/h (6.2 to 9.3 MPH) for 5 minutes e in, then change to normal travel.