. SAFETY PRECAUTIONS FOR OPERATION OPERATION 2 - 24 STARTING WITH BOOSTER CABL ES ethod of connecting the booster y to explode, so always do as nd rubber gloves when starting chine to a problem machine with normal machine with the same machine. r cable, carry out the starting e worker sitting in the operator's h the battery). machine, do not allow the two cables, turn the starting switch to e normal machine and problem t the machine will move when the (+) cable first when installing the e negative (-) cable (ground side) If the engine with booster cable.
When connecting a normal ma booster cables, always use a battery voltage as the problem When starting with a booste operation with two workers (on seat and the other working wit When starting from another machines to touch. When connecting the booster the OFF position for both th machine. There is a hazard tha power is connected. Be sure to connect the positive booster cables. Disconnect th first when removing them. When removing the booster ca bles, be careful not to let the booster cable clips touch eac h other or to let th e clips touch the machine.
For details of the starting proce dure when using booster cables, see "Starting Engine with Booster Cables ( PAGE 3-151)" in the OPERATION se ction. CHECKS BEFORE OPERATION If t he checks before starting are n ot carried out properly, the machine will be unable to disp lay its full performance, and there is also danger that it m ay lead to serious personal injury or death. When carrying out the checks, m ove the machine to a wide area where there are no obstr uctions, and pay c areful attention to the surrounding area . Do not allow anyone near the machine. ere is danger that you may be at and suffer serious injury when ly.
he machine matches the display If it does not match, replace it ontrol pattern card. of the machine, work equipment, ystem. sound of the machine, vibration, lso that there is no leakage of oil out repairs immediately. Always wear the seatbelt. Th thrown out of the operator's se the brakes are applied sudden Check that the movement of t on the control pattern card. immediately with the correct c Check the operating condition arm, boom, travel, and swing s Check for any problem in the heat, smell, or gauges; check a or fuel. If any problem is found, carry