INTRODUCTION INTRODUCTION This shop manual covers the following BRP made 2009 Sea-Doo watercraft models. The information and component/system descrip- tions contained in this manual are correct at time of writing. BRP however, maintains a policy of continuous improvement of its products without imposing upon itself any obligation to install them on products previously manufactured. Due to late changes, there may be some differ- ences between the manufactured product and the description and/or specifications in this document. BRP reserves the right at any time to discontinue or change specifications, designs, features, mod- els or equipment without incurring obligation.
ENGINE IDENTIFICATION NUMBER (E.I.N.) The Engine Identification Number is located on front end of the engine. VEHICLE INFORMATION HULL IDENTIFICATION NUMBER (H.I.N.) The hull identification number is composed of 12 digits: YDV 12345 L 4 95 Model year Year of production Month of production Manufacturer Serial number (a letter may also be used as a digit) It is located on footboard at the rear of watercraft. 1. Engine Identification Number (E.I.N.) WORKING ON WATERCRAFT To work on watercraft, securely install it on a stand. Thus, if access is needed to water inlet area, it will be easy to slide underneath water- craft.
The LIFTING STRAP (P/N 529 036 171) MUST be used to install watercraft on a stand. smr2009-011-001_a 1. Hull Identification Number (H.I.N.) NOTICE Using any other lifting strap kit than the recommended one will cause damages to the vehicle. Bumpers will be tear off and their replacement will be required. X smr2009-011 MODEL COLOR ENGINE MODEL NUMBER GTX Limited iS Topaz mist metallic 1503 HO (255 HP) 189A, 189B RXT iS Bright yellow 1503 HO (255 HP) 349A, 349B