INTRODUCTION Threadlocker Application for Case-In Components (Metallic Gaskets) 1. Proper strength Loctite 1. Clean inner housing diameter and outer gasket diameter. 2. Spray housing and gasket with LOCTITE PRIMER N (P/N 293 800 041) . 3. Apply a strip of proper strength Loctite on lead- ing edge of outer metallic gasket diameter. NOTE: Any Loctite product can be used here. A low strength liquid is recommended as normal strength and gap are required. 4. Install according to standard procedure. 5. Wipe off surplus. 6. Allow it to cure for 30 minutes. NOTE: Normally used on worn-out housings to prevent leaking or sliding.
It is generally not necessary to remove gasket compound applied on outer gasket diameter. smr2009-011 XIX