Section 01 MAINTENANCE Subsection 01 (MAINTENANCE SCHEDULE) 2 smr2009-011 A: Adjust C: Clean I: Inspect L: Lubricate R: Replace O: Operator D: Dealer FIRST 10 HOURS 25 HOURS OR 3 MONTHS 50 HOURS or 6 MONTHS 100 HOURS or 1 YEAR 200 HOURS or 2 YEAR TO BE PERFORMED BY NOTE 50 HOURS or 6 MONTHS 100 HOURS or 1 YEAR 200 HOURS or 2 YEAR TO BE PERFORMED BY NOTE 200 HOURS or 2 YEAR TO BE PERFORMED BY NOTE PART/TASK NOTE ELECTRICAL SYSTEM Spark plug I I R D (5) Inspect operation before each ride. (6) Inspect once a month. Add electrolyte as required. Electrical connections and fastening (ignition system, starting system, fuel injectors etc.) I I D D.E.S.S.
key/post (5) I I D Monitoring beeper I I D Battery and fasteners I I (6) D STEERING SYSTEM Steering cable and connections I I D (5) Inspect operation before each ride. (7) See NOTE 2 after maintenance schedule. (10) Check operation. Steering nozzle bushings I I D O.T.A.S. (10) I I D iTC and iBR levers (5) (7) I, L D PROPULSION SYSTEM Carbon ring and rubber boot (drive shaft) I I D (4) At storage period or after 100 hours of use whichever comes first. (8) Inspect each month (more often in salt water use) and change when necessary.
Impeller boot I I D Impeller shaft seal, sleeve and O-ring I (4) D Drive shaft/impeller splines I, L D Sacrificial anode (if so equipped) (8) D Impeller and impeller wear ring clearance I I D Pump mounts I I D iBR SYSTEM (intelligent Brake/Reverse) iBR gate backlash I I D — iBR support plates I I D iBR friction sleeves I R D iBR connecting arms, sleeves, and bushings I I D iBR U lever, VTS trim ring, iBR gate and bushings I I D iBR locking sleeve I R D iBR protective guard I I D iS SYSTEM (intelligent Suspension) iS fluid (9) I I D (9) Check pump reservoir fluid level and check for system leaks. iS position sensor I I D