0A-22 General Information Never insert the probes (1) from the connection closure area of the connector, as this will cause the connector terminals to break. 2. Push the lock (2) up in the direction of the arrow using the metal rod to release the lock. In that state, pull out the harness (3) together with the terminal (4). NO 1 2 1 4 3 5 LNW20ASH001601 LNW20ASH001801 Inspection requirements for waterproof connector circuit —Terminal lock type For waterproof connectors, the probes of the tester cannot be inserted from the wiring side, due to the structure of the connectors.
Therefore, perform the continuity inspection as indicated in the diagram, by connecting a testing connector (1) prepared in advance to the connector (2) to test, and connect the probes (3) of the tester to the harness of the testing connector. 1. Insert a metal rod (1) from the connector closure area (5). 2. As indicated in the diagram, release the terminal lock (2) by pushing it to the harness side, pull out the harness (3) together with the terminal (4). 1 2 3 1 2 4 5 3 LNW20ASH001901 Connecting connector terminals LNW20ASH001701 1. Check that the terminal lock (1) area is raised fully and can be locked. 2.
Insert the terminal (3) from the harness (2) side of the connector, and push it in until the lock area clicks. Disconnecting connector terminals —Built-in lock type 1. As indicated in the diagram, insert a thin screwdriver-shaped metal rod (1) from the connector closure area (5).