General Information 0A-29 Parts of the CAN-di module [Euro4 specification] 1 LNW7Z0SF000501 2 1. Tech2 connecting cable Connects the CAN-di module to the Tech2. 2. DLC connecting cable Connects the CAN-di module to the Tech2 adaptor 2. LHD model Connection method 1. Insert the ISUZU system PCMCIA card into the Tech2 unit. 2. Connect the DLC cable to the Tech2 unit. 3. Connect the CAN-di module to the DLC cable. [Euro4 specification] 4. Connect the Tech2 24 V adaptor 2 to the CAN-di module. [Euro4 specification] Connect the Tech2 24 V adaptor 2 to the DLC cable. [Except Euro4 specification] 5. Confirm that the ignition is turned "OFF". 6.
Connect the Tech2 24 V adaptor 2 to the vehicle side DLC connector (pole 16, blue). RHD model 9 1 10 11 3 2 13 12 5 4 15 16 14 6 8 7 MFW82ASH000401 NOTE: The CNG engine becomes sensitive to fluctuation of the power voltage when the temperature of ECM unit is high while or after driving, and communication failures may occur. To avoid this situation, input 12 V power supply from a 12 V battery using a battery power cable, separately from the power for the Tech2 24 V adaptor 2. Do not input 24 V battery power supply to the Tech2 unit. Do not use the cigar lighter power supply on the vehicle side, which is also 24 V. 9 1 11 10 3 2 13 12 5 4 15 14 6 7 16 8 MFA7Z0SH000201