SAFE OPERATION - 3 4. Do not stop or start suddenly when going uphill or downhill. Be especially cautious when changing direction on slopes. 5. If vehicle stops or loses power going up a hill, lock parking brake to hold vehicle on slope. Maintain direction of travel and release brake slowly. Back straight downhill while maintaining control. Do not turn vehicle sideways. Vehicle is more stable in a straight forward or rearward position. 6. When riding on soft terrain, turn front wheels slightly uphill to keep vehicle on a straight line across the hill. 7. If the vehicle begins to tip, turn front wheels downhill to gain control before proceeding.
(1) To avoid upsets, always back up steep slopes. If you cannot back up the slope or if you feel uneasy on it, do not operate on it. Stay off slopes too steep for safe operation. (2) Driving forward out of a ditch, mired condition or up a steep slope increases the risk of a vehicle to be upset backward. Always back out of these situations. Extra caution is required with four- wheel drive mode because the increased traction can give the operator false confidence in the vehicle's ability to climb slopes. (3) Keep all movement on slopes slow and gradual. Do not make sudden changes in speed, direction or apply brake and make sudden motions of the steering wheel.
(4) Special attention should be made to the weight and location of implements and loads as such will affect the stability of the vehicle. 3. Turn the headlights on. 4. Drive at speeds that allow you to maintain control at all times. 5. Do not apply the differential lock while traveling at high speeds. The vehicle may run out of control. 6. Avoid sudden motions of the steering wheel as they can lead to a dangerous loss of stability. The risk is especially great when the vehicle is traveling at high speeds. C Other miscellaneous 1. Clean platform if dirty and remove any debris from around foot controls. 2. Always keep both hands on the steering wheel. 3.
Always keep arms and legs inside the operating compartment. 4. Never operate the vehicle while standing. 5. Do not tow a cart with any riders on it. 6. Never attempt wheelies, jumps or other stunts. 3. HAULING LOADS IN THE CARGO BED 1. No riders in cargo bed or anywhere else. 2. Do not overload vehicle. Securely anchor all loads. 3. Be sure load is evenly distributed. 4. Reduce cargo capacity when operating on rough or hilly terrain. 5. Balance loads evenly and secure them. Braking could shift the load and affect vehicle stability. 6. Never operate vehicle with the cargo bed raised. 7. Operate cargo bed dump with vehicle stationary and parking brake locked. Do not dump while moving. 8.
Operate hydraulic dump on level ground only. 9. Operate dump from operator's seat only. 10.Do not place hands or body under the cargo bed when lowering bed. C Operation in inclement conditions 1. Only operate during daylight or with good artificial light. 2. Operate vehicle in an open, unobstructed area. 3. Use helmet and/or protective gear for certain operating conditions. 4. Reduce speed according to trail, terrain and visibility conditions. 5. Never drive exceeding the limit of visibility. Slow down near crest of hill until getting a clear view of the other side. 6. Stay alert for holes, rocks and other hidden hazards in the terrain. 7.
Never cross any body of water where depth may be unknown to the operator (Deep water is considered anything in excess the bottom edge of the axle cap). Choose a course within the waterway where both banks have a gradual incline. Cross at a point known to be safe. 4. PARKING THE VEHICLE 1. Lower all implements to the ground, place all control levers in their neutral positions, set the parking brake, stop the engine, and remove the key. 2. Make sure that the vehicle has come to a complete stop before dismounting. 3. Avoid parking on steep slopes, if at all possible park on a firm and level surface; if not, park across a slope with chock the wheels and always with attachment on the ground.
Failure to comply with this warning may allow the vehicle to move and could cause injury or death. C Driving the vehicle at high speeds 1. Check the front wheel engagement. The braking characteristics are different between two and four wheel drive. Be aware of the difference and use carefully. 2. Always slow the vehicle down before turning. Turning at high speed may tip the vehicle over.