Kubota — Flushing Cooling System and Changing Coolant

71 PERIODIC SERVICE EVERY 500 HOURS EVERY 2 YEARS B Replacing Fuel Filter Consult your local KUBOTA Dealer for this service. B Changing Brake Fluid Consult your local KUBOTA Dealer for this service. (See "Checking Brake Fluid Level" in "DAILY CHECK" in "PERIODIC SERVICE" section.) EVERY 800 HOURS B Adjusting Engine Valve Clearance Consult your local KUBOTA Dealer for this service. B Flushing Cooling System and Changing Coolant EVERY 1500 HOURS B Checking Fuel Injection Nozzle Injection Pressure Consult your local KUBOTA Dealer for this service. To avoid personal injury: A Do not remove the radiator cap while coolant is hot.

When cool, slowly rotate cap to the first stop and allow sufficient time for excess pressure to escape before removing the cap completely. EVERY 3000 HOURS B Checking Injection Pump Consult your local KUBOTA Dealer for this service. 1. Stop the engine and let cool down. 2. To drain the coolant, open the radiator drain plug and remove radiator cap. The radiator cap must be removed to completely drain the coolant. 3. After all coolant is drained, close the drain plug. 4. Fill with clean water and cooling system cleaner. 5. Follow directions of the cleaner instruction. 6. After flushing, fill with clean water and anti-freeze until the coolant level is just below the radiator cap.

Install the radiator cap securely. 7. Fill with fresh water up to the "FULL" mark on the recovery tank. 8. Start and operate the engine for few minutes. 9. Stop the engine and let cool. 10.Check coolant level of recovery tank and add coolant if necessary. EVERY 1 YEAR B Replacing Air Cleaner Primary Element and Secondary Element (See "Cleaning Air Cleaner Primary Element" in "EVERY 100 HOURS" in "PERIODIC SERVICE" section.) (1) Drain plug (2) Rear tire (LH) Coolant capacity 4.0 L (4.2 U.S.qts.)