Lubrication and Service - Section 40 08/11 OM4041 Page 40-6 250 HOUR INSPECTION (continued) 3 4 5 6 7 8 9 10 11 12 13 14 Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS ALTERNATOR BELT - Check the alternator belt for cracks, glazing or cuts. Check for proper tension. Repair or adjust as necessary. AIR CONDITIONER COMPRESSOR BELT - Check the compressor belt for cracks, glazing or cuts. Check for proper tension. Repair or adjust as necessary. FAN BELT - Check the fan belt for cracks, glazing or cuts. Check for proper tension.
Repair or adjust as necessary. TRANSMISSION CASE BREATHERS - Remove breathers, disassemble breathers, remove filter ele- ment, and clean in solvent. Dry with pressurized air, reassemble, then reinstall. HYDRAULIC TANK BREATHER - Remove breather, and disassemble. Remove the filter element. Replace the filter element, reassemble, and reinstall. DIFFERENTIAL CASE - Check the oil level. Use lube key "B". DIFFERENTIAL CASE BREATHER - Remove breather. Wash to flush out the dirt from inside. Rein- stall after cleaning. FINAL DRIVE CASE - Check the oil level in RH and LH case. Use lube key "B". PARKING BRAKE - Measure brake pad for proper wear and thickness.
Refer to Section J, Brake Sys- tem, in the shop manual for limits and specifications. Use lube key "D" chart. FUEL FILTER - Remove and replace fuel filter ele- ments. CORROSION RESISTORS - Remove and replace corrosion resistor elements. DUMP BODY PADS - Check the pads, shims and mounting hardware for wear and proper tightening.