OM6010 Payload Meter II - Section 60 Page 60-17 DISPLAYS AT START-UP 6. The display will show: This function is not used. POWER ON: "SU : - -" indicates Switch 8 is up. All external display lamps (Figure 60-2) will come on and stay on for approximately 27 seconds during the "Power-up Process". "SU : oo" indicates Switch 8 is down. 7. The display will show: The "Power-up Process" will display the PLM II™ settings. Each display will occur for approximately 3 seconds: This display indicates the Machine ID code where "xxx" indicates a value between 0 and 200. 8. The display will show: 1. The display will show:
This display indicates the Opera- tor ID code where "xxx" indicates a value between 0 and 200. In addition, a buzzer will sound and the following lamps will light for 3 seconds: Reception Pilot Lamp (2, Figure 60-1) 9. The display will show: Transmission Pilot Lamp (3, Figure 60-1) This display indicates the Speed Limit setting where "xx" indicates a value between 0 and 99 km/h. Memory Card Pilot Lamp (4, Figure 60-1) 2. The display will show: The "xx" indicates the Truck Model. Refer to "Initial Setup of Payload Meter" for code definitions. 10. The display will show: This display indicates the Option code setting. 3. The display will show:
Refer to "Operator Check Mode, Setting the Option Code" and to "Method of Operation" for more information on this function. This display indicates the status of the Memory Card where: "Cd : - -" indicates Card Not Used, and "Cd : oo" indicates Card Is Used. 4. The display will show: Normal Operation This display indicates the status of the Inclinometer for the PLM II™, where If the truck engine is started before the preceding "Power-up Process" is completed, the display will shift to normal operation. "CL : - -" indicates Inclinometer Not Used, and "CL : oo" indicates Inclinometer Is Used.
If the engine is running when the payload meter starts up, only "o:XXX" and "d:XXX" will display before switching to normal operations. 5. The display will show: This display indicates method of measurement where: "US : - -" indicates METRIC Tons. "US : oo" indicates U.S. Tons.