OM3212 08/11 Operator Cab and Controls - Section 32 Page 32-21 LH Control/Indicator Panel (Pod) LH control/indicator panel (5, Figure 32-6), located to the left of the steering wheel, contains the following: Engine Oil Temperature Engine oil temperature monitor light (2, Figure 32-9) will illuminate if the engine oil temperature exceeds 121°C (250°F) for a continuous period of 5 seconds. If the lamp flashes and alarm buzzer sounds, stop the engine. At the same time, a fault code will be registered in the Quantum™ System. Refer to Quantum™ Fuel System Diagnostics later in this section.
Engine Coolant Level Engine coolant level monitor light (3, Figure 32-9) will illuminate, if the engine coolant level is below the sen- sor for a continuous period of five sec- onds. At the same time, a fault code will be registered in the Quantum™ System. (Refer to Quantum™ Fuel System Diagnos- tics later in this section.) If this monitor lamp flashes and the alarm buzzer sounds, stop the truck, shut- down the engine, and add coolant, as required. FIGURE 32-9. LH CONTROL/INDICATOR PANEL 1. LH Panel (Pod Assy.) 2. Engine Oil Temp. 3. Engine Coolant Level 4. Low Steering Pressure 5. Accumulator Pre-Charge Pressure 6. Battery Charge (Amps) 7. Check Engine 8. Parking Brake 9. Body Float 10.
Transmission Oil Temperature 11. Service Brakes Applied 12. Maintenance Monitor 13. Transmission Oil Filters 14. Lamp Test Switch 15. Low Brake Pressure 16. Lateral Slope Warning 17. Crankcase Pressure 18. Panel Dimmer Switch 19. Engine Oil Pressure 20. Central Warning Lamp 21. A/C & Heater Vent Low Steering Pressure Low steering pressure monitor light (4, Figure 32-9) will illuminate if the steer- ing system pressure is below 12.8 MPa (1850 psi). The light may also indicate that the wire from the switch to the transmission controller is cut or broken.
Accumulator Pre-Charge Accumulator pre-charge monitor light (5, Figure 32-9) will illuminate if the accumulator nitrogen pressure is below 5861 kPa (850 psi). The light may also indicate that the wire from the switch to the transmission control- ler is cut or broken. LH Panel/Pod Assembly LH panel/pod (1, Figure 32-9) provides an array of indicator/monitor lights and three switches. NOTE: All the indicator lamps are red in color; except, #11. which is amber/yellow.