Replica 1 plus Users Manual Step 12: Install the 10uF electrolytic capacitor. This capacitor is cylinder shaped and black. They are polarized and the longer lead is the positive side. The negative side has an arrow pointing down to the lead to help out. Place the capacitor so it is flush with the board. Bend the pins slightly away from one another to help hold the position and turn the replica 1 over. Solder the 2 leads and cut the excess off. Figure 21: 10uF electrolytic capacitor Step 13: Install the video connector so that the round metal connector points out away from the board. Hold the connector and turn the board over and place on your workbench.
Solder the two pins down and use enough solder to fill the holes completely. Figure 22: video connector Step 14: Install the 44 pin slot connector into its position. Notice that the socket may have identification of the pin number on top of the socket. Look for the Z or the A and match it up with the board identification marks. Hold the slot into position flush with the board and turn the replica 1 over. Solder 1 pin down and check that the slot is flush with the board. Continue to solder the remaining pins until all 44 are soldered down. Figure 23: 44 pin card slot © Briel Computers 2014 page 18