Items of Special Importance General CAUTION: In the event of the engine stalling while the vehicle is in motion, power assistance to the steering will be lost and, consequently, greater effort will be required to steer the vehicle. The engine turbocharger is a preci- sion instrument. For this reason the fol- lowing operating procedures should be observed: When starting the engine, do not allow it to exceed its idling speed for 10 seconds; this procedure will ensure that adequate oil pressure is available at the turbocharger bearings thus preventing initial oil starvation.
During the “break-in” period do not subject the new vehicle to excessive loads; this also applies when an over- hauled engine, transmission, or differ- ential has been installed. After a cold start continue to drive in a low gear and at a moderate engine speed until the engine coolant tempera- ture has reached 140°F (60°C). Check the instrument panel regularly when driving and take immediate steps to rectify possible problems at the first sign of trouble. Do not let the engine idle for longer than necessary. This is harmful for the engine and also causes unnecessary pollution of the environment. To prevent damage to the vehicle, the following instructions must be strictly observed.
The following “break-in” recommenda- tions should be applied during the first 1,000 miles (1,600 km) of a new vehi- cle: Do not operate at full engine power in any gear. Do not allow the engine to labor in any gear. Do not allow the engine to run at idling speeds for excessive periods. Items of Special Importance Break-in