3. Operation Manual Operation (Seawater Cooling Only) 1. Open the Kingston cock. 2. Open the fuel tank cock. 3. Set the remote control lever in NEUTRAL 4. Pull out the decompression lever. 5. Put the starter handle on the starter shaft, align the groove and pin, and turn by hand. When you begin turning, you will hear the sound of fuel being injected. 6. Turn the handle vigorously. When the rotation is rapid, return the decom- pression lever to original position. The engine starts. 7. Remove the starter handle from the Ma nua l start pos i ti on starter shaft.
(2) Restarting After Starting Failure Before pushing the start button again, be sure to confirm that the engine has sto pped completel y. If the engine is restarted while the engine still has not stopped, the pinion gear of the starter motor will be damaged. El ectric Operation ~~ rl. ::.,; Do not hold the start button on for more than 15 seconds at a time . If the engine does not start the first time , wait for about 15 seconds before trying again . After the engi ne has started, do not turn the key off . (It shou ld remain ON.) Alarm devices will not work when the key is OFF. Q) Decomp.
lever @ Drive @ Decompression (3) Air Venting of the Fuel System After Starting Failure If the engine only idles and won't start a ft er several attempts, there may be air in the fuel system. If air is in the fuel system, fuel cannot reach the fuel injection pump. Vent the air in the system according to the following procedures. 28 ••