Engine Disassembly (00-01) Coolant - Drainage N14 Page 0-11 NOTE: The maximum oil pan capacity is 34 liters [9.0 U.S. gallons]. Remove the drain plug and the copper washer. Check the copper washer for wear. Drain the oil. If the drain plug is installed again, tighten the plug to the specified torque. Torque Value: 136 [100 ft-lb] Coolant - Drainage Remove the plugs from the engine and open the cylinder block draincock and the oil cooler draincock. Use a suitable container to catch the coolant as it is drained. Coolant Filter - Removal Use a water and fuel filter wrench, Part No. 3376807, to remove the coolant filter. Lubricating Oil Filter - Removal Use an oil filter wrench, Part No.
3375049, to remove the lubricating oil filter.