Engine Disassembly (00-01) Engine - Installation on the Rebuild Stand N14 Page 0-17 Install the mounting plate adapter on the rear water header. Use five 1/4-20 X 1 1/4-inch capscrews to mount the adapter. Tighten the capscrews. Torque Value: 10 [7 ft-lb] Install three 1/2-13 X 3 3/8-inch capscrews through the adapter plate as shown. Install the three adapter plate spacers over the capscrews. Use a lifting fixture, Part No. ST-125 or 3822512, to lift the engine. Align the exhaust side of the engine to the adapter plate of the rebuild stand.
Installation such as short and medium nose conventional chassis, the factory installed rear engine lifting brackets are usually removed due to space contraints. In this case, the portable rear engine lifting bracket, Part No. 3823835, will be required to install the engine onto the rebuild stand. Align the mounting hole in the adapter plate (1) with the capscrew hole (2) in the mounting plate adapter. Use a 5/8-11 X 1 3/4-inch grade 5 capscrew to mount the adapter plate to the mounting plate adapter. Use your fingers to tighten the capscrew.