Rocker Housing Covers - Removal Engine Disassembly (00-01) N14 Page 0-34 Rocker Housing Covers - Removal Remove the ten capscrews from each rocker lever cover. Remove the rocker lever covers. The rocker housing cover gaskets can be used again if they are not dam- aged. Caution: Do not clean reusable gaskets with any solvent or steam. Solvent and steam will damage the gasket material. Clean only with soap and water. Engine Brakes - Removal Disconnect the C-Brake harness wire from the electrical connector on each C-Brake housing. Remove the capscrews from each C-Brake housing. Remove the C-Brake housing. Remove the C-Brake housing gasket.
Rocker Lever Shaft Assemblies - Removal Loosen the valve and injector adjusting screw lock nuts on each rocker lever. Turn the adjusting screws counterclockwise until the rocker levers are loose. Caution: Do not attempt to remove or install the rocker lever shaft assemblies without first loosening the levers. Remove the rocker lever shaft capscrews and the rocker lever shaft assemblies. NOTE: To prevent increased wear, mark each rocker lever as it is removed so it can be installed back in its original location. NOTE: Hold the shaft at both ends so that the rocker levers do not slide off.