CAB AND FRAME 2-15 STEP Front Step (Except NPS Front Rigid Suspension Model) Component N2A0034E Legend 1. Front door check arm pin 5. Clip 2. Check arm bracket 6. Bolt 3. Clip 7. Headlamp lower cover 4. Front step assembly Removal 1. Tighten the mounting bolt of front step assembly to the specified torque. 1. Headlamp lower cover Pull the mating part of clip to remove it. 2. Front combination lamp 3. Front door check arm pin Tighten: Mounting bolt to 15 N m (1.5 kg m/11.1 lb ft) 2. Tighten the mounting bolt of check arm bracket to the specified torque. Expand the notch on the tip of pin to remove, and tap the pin from the bottom with a plastic hammer. 4. Check arm bracket Tighten:
Mounting bolt to 25 N m (2.5 kg m/18.4 lb ft) 3. Make sure that the clip gets caught the tip of check arm pin securely. Remove the 2 mounting bolts on the door side. 5. Front step assembly Remove the 3 mounting bolts, 2 screws and a clip. Installation For installation, reverse the removal procedure taking the following points into consideration.