2-26 CAB AND FRAME Legend 1. Instrument panel assembly 6. Washer tank/bracket 2. Instrument center/side stay 7. Instrument reinforcement assembly 3. Defroster nozzle/ventilation duct 8. Instrument support bracket (wide cab model) 4. Intermediate duct (wide cab model) 9. Body harness/controller/radio 5. Brake/clutch fluid reserve tank Removal 1. Instrument panel assembly Tighten: G: Clutch pedal bracket upper bolt to 37 N m (3.8 kg m/27 lb ft) H: Steering column bracket bolt to 20 N m (2.1 kg m/ 14 lb ft) I: Brake pedal bracket upper bolt to 42 N m (4.3 kg m/ 32 lb ft) Tighten the other bolts and nuts to the standard torque. 2. Perform air bleeding for the brake and clutch.
Refer to “Instrument panel assembly” in this Section. 2. Instrument center/side stay Remove the mounting bolts A — D. 3. Defroster nozzle/ventilation duct Refer to “Heater/Air Conditioner Workshop Manual”. 4. Intermediate duct (wide cab model) 5. Brake/clutch fluid reserve tank Remove the level switch connector and remove the 4 nuts. Extract the fluid and remove each tube. Caution: Don’t apply the brake/clutch fluid to the resign portions and painted portions in any case. 6. Washer tank/bracket Remove the washer motor connector and washer tube and remove the two bolts fixing the bracket and the one bolt in the lower part of the tank. 7.
Instrument reinforcement assembly Remove all the connectors of electrical equip- ments. Remove the mounting bolts E — K. When the vehicle is provided with a manual air conditioner, remove each control cable. For re- moval, refer to “Heater/Air conditioner Work- shop Manual”. 8. Instrument support bracket (wide cab model) Remove the bolts L and M and remove the in- strument support bracket from the instrument reinforcement assembly. 9. Body harness/controller/radio Remove the body harness/controller/radio from the instrument reinforcement assembly. Refer to “Electrical Equipment Workshop Manual” and “Heater/Air Conditioner Workshop Manu- al”.
Installation For installation, reverse the removal procedure taking the following points into consideration. 1. Tighten each bolt to the specified tightening torque.