CAB AND FRAME 2-49 N2A0086E N2A0088E Legend 1. Outside door release handle 1. Meter cluster Refer to “Meter Assembly” in Meter Section. 2. Tail/stop lamp malfunction warning relay Installation Release the claw to remove it together with bracket. To install, follow the removal steps in the reverse order, noting the following point: 1. Tighten the mounting bolt to the specified torque. Disconnect the connector (1). Remove the distributor (3) from bracket. Tighten: Outside door release handle mounting bolts to 13 N m (132.6 kg cm/113 lb in) — 18 N m (1.8 kg m/13 lb ft) Remove the mounting screw and remove the control unit (2) together with bracket (4). 3. Register the ID code.
Refer to “Keyless Entry” in Wiring Diagram Section. 4. Check whether the keyless entry system operates properly. Keyless Entry Control Unit Removal Installation For installation, reverse the removal procedure taking the following points into consideration. N2A0087E