2-62 CAB AND FRAME Removal 8. Roof ventilator grille (High cab/wide cap; option equipment) 1. Disconnect the battery ground cable. 2. Sun visor/holder/grommet (Standard cab) Remove the 2 mounting screws to remove the sun visor. Refer to “Roof Ventilator” in this Section. 9. Front grip/front pillar trim cover Refer to “Front Pillar Trim Cover” in this Sec- tion. 10. Rear upper trim cover Pull the sun visor holder while rotating it 45 ° . Pry the sun visor grommet with a bladed screw- driver. 3. Room lamp/mirror (Standard cab) Refer to “Rear Side Trim Cover” in this Section. 11.
Clip Pry the room lamp lens with a bladed screw- driver, and remove the 2 mounting screws of room mirror to disconnect the connector. 4. Header shelf (High cab, wide cab except limited model) Standard cab; Top: 3 positions, Rear: 2 posi- tions High cab, wide cab; Top: 3 positions, Front: 4 positions (High cab), 5 positions (Wide cab), Rear 3 positions 12. Rear retainer/clip (High cab, wide cab) Refer to “Header Shelf” in this Section. 5. Assist grip Open the covers at 2 positions and remove the mounting screws. 6. Coat hanger Remove the clip to remove the retainer. 13. Body side finisher (upper) Pull only the upper side from panel flange. 14. Head lining 15.
Insulator Turn it 45 ° for removal. 7. Fluorescent (Option equipment) Installation Refer to “Fluorescent Working with Room Lamp” in Repair Manual for electrical equip- ment. For installation, reverse the removal procedure. Head Lining (B Pack Model) Component N2A0102E