OWNER 爷 S MANUAL JAC HEAVY DUTY TRUCK 1. IMPORTANT INFORMATION 2. BEFORE DRIVING YOUR JAC The followings are very important for the correct management and economic use of JAC vehicles, and they shall be read BREAKING IN YOUR VEHICLE carefully before use and maintenance. Operate the vehicle at moderate speeds during the first 1,000 km (600 miles) to break it in. Make certain that the follow 鄄 Nameplate The nameplate is located near the VIN, on which it marked with information ing points in particular are strictly observed. 荫 Allow the engine to warm up fully until the coolant temperature reaches about 60 益 (140 ).
about the vehicle, such as its vehicle model, engine model, ex-works date, 荫 Avoid racing the engine, abrupt start, acceleration and braking. etc. 荫 Avoid overloading the vehicle, as this will result in a shorter life. Chassis number 荫 Avoid high speed operation as far as possible. During break-in operation, make sure that the engine speed does not exceed 1,500 rpm. The chassis number, that is VIN code number, is stamped on the outer side of Make sure that your vehicle does not miss the first 1,000 km(600 miles) and 5,000 km (2,500 miles ) inspections. the right longeron end of the frame.
After the first 1,000 km (600 miles) and 5,000 km(2,500 miles) or driving, take your vehicle to your nearest service shop for inspections based on the 'Maintenance Requirements'. Overload NOTE: Must have the engine of your vehicle checked at the authorized JAC service station. If you do not follow the pre 鄄 Overloading will shorten vehicle's service life, but also bring about potential caution it may cause a series damage to the engine and is not covered by JAC. risk to safe driving. The loading mass must be limited to the specified range of the max.
total mass for vehicle, and the load distributions on the front and rear shafts shall not be more than the carrying capacity of the vehicle shafts. Please refer to the techni 鄄 cal specification sheet for the rated total mass value and shaft loading capacity. 2 3