21 PERIODIC SERVICE ENGLISH B Dust indicator (optional) If the red signal on the dust indicator attached to the air cleaner is visible, the air cleaner has reached the service level. Clean the element immediately, and reset the signal with the "RESET" button. FAN BELT B Adjusting Fan Belt Tension To avoid personal injury: A Be sure to stop the engine and remove the key before checking the belt tension. A Be sure to reinstall the detached safety shield after maintenance or checking. 1. Stop the engine and remove the key. 2. Apply moderate thumb pressure to belt between the pulleys. 3.
If tension is incorrect, loosen the alternator mounting bolts and, using a lever placed between the alternator and the engine block, pull the alternator out until the deflection of the belt falls within acceptable limits. 4. Replace fan belt if it is damaged. (1) "RESET" button (2) Dust indicator (3) Service level (4) Signal ELECTRIC WIRING A If belt is loosen or damaged and the fan is damaged, it could result in overheats or insufficient charging. Correct or replace belt. To avoid personal injury: C Shorting of electric cable or wiring may cause a fire. A Check to see if electric cables and wiring are swollen, hardened or cracked. A Keep dust and water away from all power connections.
Loose wiring terminal parts, make bad connections. Be sure to repair them before starting the engine. Damaged wiring reduces the capacity of electrical parts. Change or repair damaged wiring immediately. (1) Fan belt (2) Bolt and nut (A) 7 to 9 mm (0.28 to 0.35 in.) (under load of 10 kgf (22.1 lbs)) Proper fan belt tension A deflection of between 7 to 9 mm (0.28 to 0.35 in.) when the belt is pressed in the middle of the span.