27 WEBM1000 Safety Section (D6T LGP (OEM)) Operation additional seat belt Lifting Capacities Roll over Protective Structure (ROPS) Maintain control of the machine. Do not overload the machine beyond the machine capacity. Ensure that the correct load chart is referenced. Loads must be within the capabilities of the machine. Lifting capacity decreases as the load is moved further from the machine. Never use the work tool as a work platform. Report any needed repairs that were noted during operation. Do not go close to the edge of a cliff, an excavation, or an overhang. Use lifting slings that are approved and use lifting slings that are load tested.
Also, all wire ropes or chains must be properly maintained. The wire ropes and chains must meet local regulations. You must know the load carrying capacity of these devices and you must know the correct use of these devices. If the machine begins to sideslip, perform the following procedure: Discard the load. Turn the machine downhill. Limitations on Lifting Loads That Exceed the Working Range Be careful to avoid any condition which could cause the machine to tip. The machine can tip when you work on hills, banks, and slopes. Also, the machine can tip when you cross ditches, ridges, or other obstacles. Do not load the boom beyond the maximum load capacity.
See Operation and Maintenance Manual, “Lifting Capacities” for the load capacity of the boom. Whenever possible, operate the machine up the slopes and down the slopes. Avoid operating the machine across the slope, when possible. When the load capacity is exceeded, refer to “American National Standards A.N.S.I. B3014”. Also, follow the procedures that are listed below: Keep the machine under control. Do not overload the machine beyond capacity. Inspect the wire cable for defects prior to the lift operation. Be sure that the towing eyes and towing devices are adequate. Inspect the wire cable for defects after the lift operation.
Towing eyes and towing devices should only be used to recover the machine. Do not exceed the load capacity of the boom. Connect trailing equipment to a drawbar or to a hitch only. The load must be handled safely in order to minimize tipping effects. The lift operation and the inspections must be made under controlled conditions by an authorized person. When you maneuver the machine to connect equipment, be sure that there are no personnel between the machine and trailing equipment. Block the hitch of the trailing equipment in order to align the equipment with the drawbar. Electrical Power Lines Never straddle a wire cable or allow other personnel to straddle a wire cable.
m WARNING When you maneuver to connect the equipment, make sure that no personnel are between the machine and trailing equipment. Block the hitch of the trailing equipment in order to align the equipment with the drawbar. Serious injury or death by electrocution can result if the machine or attachments are not kept the proper distance from electrical power lines. Use the following charts in order to determine the safe distance from high voltage wires during these conditions: Know the maximum dimensions of your machine. Always keep the Rollover Protective Structure (ROPS) installed during machine operation. machine operation machine transportation